#ROXIO EASY VHS TO DVD SUPPORT FORUMS MANUAL#
If this does not resolve the issue, please consult with your VCR's owner's manual for information on adjusting the tracking control. When this happens, VHS to DVD will lose track of the video frame resulting in a "No Video Signal".Ī common way to adjust tracking on your VCR is to press the Channel UP or DOWN controls, either on the VCR or on its remote control. The result will be scrambled video, discoloration, video distortion, etc. On occasion, the VCR might lose tracking on the tape. If there is no actual recording on the VHS tape, there will be no frame to lock on and it will result in No Video Signal. If the VCR is powered on and you still get this message, try playing a VHS tape for 30 seconds to see if Easy VHS to DVD will detect a Video Signal and lock on to a frame. This can also occur when a connected VCR is turned off. Similarly, the red and white audio RCA composite audio cables should be connected to the red and white audio output jacks on your VCR and the red and white audio input jack on your Roxio Video Capture device. The yellow RCA composite cable for video should be connected to the yellow RCA video output jack on your VCR and the yellow RCA video input jack on your Roxio Video Capture device. Most of the reviews and questions about whether it works seem to top out at 10.8.x.
For system requirements, it only says 10.6 or higher. This is the only Mac product I found (other than Roxio's) that was of the simple/inexpensive conversion process. If you are using RCA cables to connect your VCR to the Roxio Video Capture device, make sure the cables are connected to the correct jacks on both your VCR and your Roxio Video Capture device with the matching colors. The last compatible OSX version Roxio lists is for 10.6. This typically occurs when your VCR is not properly hooked up to the Roxio Video Capture device.
0 kommentar(er)
